Become certified to use the 3D printers in the brand new Ignite Studio! Reservations to use the equipment are contingent on the completion of this certification course. The course covers safety guidelines, a brief introduction to Cura software, and an overview of our Robo3D printers. Registration is required and your spot will be held for 10 minutes after the start time. After 10 minutes, open spots will be filled with walk-ins. Walk-ins must check in with staff. For ages 16+.
Event Type(s): Adult Programs, Teen Programs
Register For Event
You must log in to register for this event.
Oops! - There was a problem in authenticating your card: