Become certified to use the 3D printers in the brand new Ignite Studio! Reservations to use the equipment are contingent on the completion of this certification course. The course covers safety guidelines, a brief introduction to Cura software, and an overview of our Robo3D printers. Registration is required but 10 minutes after the start time, open spots will be filled with walk-ins. Walk-ins must check in with staff. Must be age 16 or over.
Event Type(s): Adult Programs, Teen Programs
Register For Event
You must log in to register for this event.
Oops! - There was a problem in authenticating your card: